1. The sprocket should be mounted on the shaft without skew and swing. In the same transmission assembly, the end faces of the two sprockets should be in the same plane. When the center distance of the sprocket is less than 0.5 m, the deviation is 1 mm. When the center distance of the sprocket is 0.... read more
It is used for the transmission equipment of material transportation and high-speed transportation which can be tripled according to normal operation. read more
The chain is generally a metal link or ring, which is mostly used for mechanical transmission and traction. Chains used to obstruct traffic passages, chains for mechanical transmission. Today, Drive Chain manufacturers will briefly describe the knowledge about chains: The chain includes four series:... read more
In life, you often see places where chains are used. So what are the correct steps when using these chains? Today, Motorcycle Chain manufacturers will share the general chain installation steps. 1. The sprocket should be mounted on the shaft without skewing or swinging. The end faces of two sprocket... read more
Below are three reasons why the Industrial Chain manufacturer is too tight. 1. Do not know the maintenance common sense, adjust it by yourself, and tighten the conveyor chain by mistake. This is a confused concept. I only know that chain adjustment is the scope of maintenance. I don't know how to ad... read more
+86-13805752016（WeChat）
+86-571-82875104/82875108
No. 80 QianNong West Road,Xiaoshan District, Hangzhou City,Zhejiang Province,China
