Why Does Leaf Chain Have Common Problems Of Deviation

With the continuous development trend in the field of stainless steel chain, stainless steel chain products have also been widely used. Among them, Leaf Chain is also widely used, but it is also prone to chain deviation. Let’s discuss how to Solve the deviation phenomenon during the use of the Leaf Chain .

　　
1. Too fast chain starting speed can also cause deviation. Start at a slow speed at this time. If the winding motor is used, it can be restarted after 2 jogs, and it can also get rid of the deviation condition reasonably.

　　
2. The initial supporting force of the chain is very small. The lack of support at the conveyor belt leaving the drum causes the conveyor belt to deviate. This type of situation usually occurs at startup, and the way to deal with it is to adjust the tensioning device to increase the initial support force.

　　
3. The end transmission roller bearing is damaged and does not rotate or the left and right roller bearings are damaged and do not rotate too much. The cause of the damage is that the tail sinks and floats too much, and there is no immediate repair and replacement of the components that have been damaged or rotate inefficiently, which increases the frictional resistance and leads to deviation.

　　
4. If the load of the stainless steel chain is too large, it will run off if it exceeds the electrical working capacity. The beneficial side of running deviation at this time is the maintenance effect on electricity. Otherwise, the electricity will be damaged after a long time. But for the operation, it is a deviation accident.

　　
5. To get rid of the deviation of the stainless steel chain conveyor belt, first look for the reason for the deviation, and then take measures to deal with it. In that way, a lot of conveniences have been produced for everyone's work.