Motorcycle Chain Manufacturer Introduces The Cleaning Method Of Stainless Steel Chain

Motorcycle Chain Manufacturer introduces stainless steel chain as universal transmission equipment. According to the hyperbolic arc "chain buckle" design scheme, sliding friction is reduced. It is used in areas with a higher driving force and slower operating speed. It is better than synchronous belts. Transmission has obvious advantages, but the speed of the transmission system cannot be too fast, because the flexibility of the transmission chain is not as good as that of the transmission belt.

 
But after each application, you must not forget to clean up the stainless steel chain, especially in rainy weather and wet and cold natural environment. It is stipulated that a dry rag should be used to clean the drive chain and parts; if necessary, an old soft toothbrush can be used to clean the gap between the chain pieces to remove the fine sand and stains deposited between the drive chain.

 
In the case of cleaning the stainless steel chain, warm soapy liquid can be used, but remember not to use strong alkali or strong alkaline cleaning liquid, because this organic chemistry can cause damage or even rupture of the transmission chain. In addition, an aqueous solution containing organic solvents should not be used to clean the stainless steel chain, as it will cause damage to the transmission chain to some extent.

 
In addition, during the whole process of cleaning the stainless steel chain, it is necessary to prevent the application of solvents such as scouring oil, which will not only pollute the environment but also wash away the grease at the position of the rolling bearing. Now when it comes to grease, pay attention to the lubrication regulations for stainless steel chains.

 
The wettability is very critical for stainless steel chains. Therefore, no matter what the structural design of the transmission chain is, it needs to carry out effective wetting. There are two ways to perform this work, one is to immediately moisturize, and the other is to clean up and then start moisturizing.

The necessary condition for immediate lubrication is that the stainless steel chain itself is relatively clean and can be immediately lubricated with grease products such as sprinkler irrigation equipment. The stainless steel chain is cleaned and cleaned and then moisturized, which is more suitable for the dirty transmission chain.