Industrial Sprocket Factory Introduces Solutions For Chain Cracking

Industrial Sprocket Factory introduces the solution for chain cracking:

The chain belongs to a kind of transmission chain of the transmission system and belongs to the type of transmission chain of the universal transmission system in the manufacturing industry. Although the product is relatively high-quality, if it is not used properly, cracking will still occur. At this time, everyone must carefully look for the cause of the cracking and immediately solve it.

For the chain, the deformation is very large within the area of ​​the edge of the hole, which is a hazardous area that is easy to cause cracking. After the sleeve, the specification can bear the bending deformation and the cutting deformation, and the very large cutting deformation is within the part The gap between the transmission chain of the transmission system and the needle bearing is a hazardous area where the sleeve specification is very easy to crack.

After the bearing capacity of the chain shaft pin, there are bending deformation and cutting deformation, and the position of very large cutting deformation is out of the gap between the transmission chain and the sleeve specification of the transmission device transmission system. Therefore, you must pay attention to checking such areas that are very easy to crack before transferring small blocks to ensure that all raw materials are transferred normally.