news

Industrial Chain Suppliers Introduces Why Chats Are Jittery

Update:21-12-2020
Summary:

What should we do when there is a jitter in the industr […]

What should we do when there is a jitter in the industrial chain? I believe this is what many people want to know very much. Then, Industrial Chain Suppliers will share the experience:

 

1. Chain jitter: The cause of industrial chain jitter is that the industrial chain is too loose, the load is too large, or one or more chain links are not flexible. The solution is to install an industrial chain tensioner or an adjustable center distance.

 

2. Coordination of industrial chain and sprocket: If the industrial chain and sprocket are not well-matched, it may be that the hinge of the industrial chain is worn and the pitch is elongated. If there is a phenomenon of tooth skipping, the industrial chain should be replaced in time.

 

3. Excessive operating noise of industrial chains: the excessive noise is caused by the non-coplanar sprocket; the chain tension is too large or too small; the lubrication is insufficient; the chain and sprocket wear; or the chain pitch is too large. The solution is to check the coplanarity of the front and rear axles parallel to the sprocket and correct them. Adjust the center distance and tensioning device to obtain proper tightness and ensure lubrication to the workpiece.

0
Contact Us