How To Use Industrial Chain Reasonably And Correctly

Industrial Chain is a very common chain, it is mainly used in an industrial environment, so what should be paid attention to when using this kind of chain. Let's take a look together below:

1. The tightness of the chain should be suitable. The tightness level of the chain is: lifted or pressed down from the middle of the chain, the center distance between the two sprockets is about 2%-3%. The new chain is too long or stretched after use. Adjust, depending on the condition, remove to the chain link, but it must be an even number. The chain link should pass through the reverse side of the chain, the lock piece should be inserted outside, and the opening teeth of the lock piece should face the opposite direction of rotation.

2. After the sprocket is severely worn, the new sprocket and the new chain should be replaced at the same time to ensure good meshing. It is not possible to just change to a new chain or new sprocket alone. Otherwise, it will cause poor meshing and accelerate the wear of the new chain or new sprocket. After the sprocket tooth surface is worn to a certain level, it should be turned over and used in time.

3. The old chain cannot be mixed with the new local chain, otherwise, there will be an impact in the transmission and the chain will be broken. The chain should be filled with lubricating oil in time during work. The smooth oil needs to enter the matching gap between the roller and the inner sleeve to improve working conditions and reduce wear. When the machine is stored for a long time, the chain should be removed and cleaned with kerosene or diesel oil, and then coated with oil or butter and stored in a boring environment.

4. The Industrial Chain has no elastic sliding and slipping, and can adhere to a precise and uniform transmission ratio. The required tension is small, and the pressure acting on the shaft is also small, which can reduce the friction loss of the bearing. It can be used in high temperature and oily conditions. Working under environmental conditions; Compared with gear transmission, the manufacturing and device accuracy requirements of chain transmission are lower, and the transmission structure is simple when the center distance is large.